Your Shopping Cart

caddy
Your Cart is currently empty.
If you’re not satisfied, for any reason, within 30 days we will refund your money, no questions asked. For more information, read our Sales and Refund Policy.

Search Products

Need Help ?

To ensure good professionalism to better serve you is our motivation.

HTM-System

Read more...
  • English (United States)
  • French (Fr)

Quick Snap fasteners can be secured without problems by using our Quick Snap adhesive for all letters made from acrylic or expanded PVC, or, by using our 2 component adhesive for letters out of aluminum, brass, stainless or ulti layer aluminum enamel. Quick Snap Letter adhesive is found on page 17.

Caution-Install

 

  • Always use stainless steel screws.
  • Tighten the screws through the fastener, then loosen a quarter of a turn.
  • The fasteners must be used exclusively for letters.
  • Use one fastener per 4’’(10 cm).
Home Products Info QS Install
Install PDF Print E-mail

Quick Snap Letter is very easy and quick to install, only 5 steps are necessary.

Our selection of quick fasteners for cut out letters «Quick Snap» system is used for the installation of letters in relief. No drilling or obviously visible screws on the face of the letters.
The system is very simple and quick to use.

The directions below are general installation recommendations. The weight of each fastener depends on the conditions of use. To avoid unnecessary tension it is advisable to avoid over tightening of the body support

Adhesive Mounted

  
  • Surface
    .
  • Body with screw
    .
  • Letter
    .
  • Head with adhesive
    .

Screw Mounted

 

 

  • Surface
    .
  • Body with screw
    .
  • Letter
    .
  • Head with screw
    .
 
 
 
 
 

 To Install your letters

 

Step 1

 
 

Step 1

Using adhesive

place the Head

support on the back

of the letters.

Step 2

 
 

Step 2

Place the letter

against the template

and use pressure to

mark placement of

pilot holes.

Step 3

 
 

Step 3

Place template and

drill appropriately

Step 4

 
 

 

Step 4

Attach Body ends

in correct positions.

Step 5

 
 

 

Step 5

Securely Snap

the letters into

place using slight

pressure.